BERTHOLD Technologies: The Tower-Sens is a rod detector based on the well-known level gauging system LB 490 Uni-Probe. It has been designed specifically to monitor large measuring ranges. With only one electronic unit and only one flameproof-housing, the Tower-Sens is significantly more economical than systems comprising several short, cascading detectors. Moreover, the wiring efforts and the risk of complete system failure are drastically reduced. The combination of good value, reliability, accuracy and low source activity make the Tower-Sens the ideal solution for measuring ranges exceeding a length of 2 meters. System highlights: - Constant high measurement accuracy over the entire measuring range, even under varying temperatures - Virtually maintenance-free - Reliable for many years - Low source activity due to the high sensitivity - Minimum radiation protection stipulations ....

Bronkhorst High-Tech proudly presents the BRIGHT Series, multifunctional Readout and Control units. These new R/C-modules offer the users of Bronkhorst Mass Flow Meters / Controllers the possibilities of local indication and operation, flowrate in actual values or percentage, fluid selection, setpoint, counter and alarms. Further to these functionalities, the compact and stylish design distinguishes this comprehensive device from other products on the market. The BRIGHT models are available for lab-style instruments (see depicted image of an EL-FLOW® Mass Flow Controller) and for instruments with IP65 housing. Communication between such an instrument and the BRIGHT module is established over the RS-232 digital communication port. The modern OLED display technology results in a bright and wide angle visibility. The BRIGHT module can be mounted either directly on the instrument, on an adjacent wall / panel or on the instrument’s pipework. For the latter options we can offer an additional mounting bracket. ...

BERTHOLD Technologies: Radiometric level gauges have proved themselves indispensable, especially in the chemical industry, due to their universal usage and reliability. The measurement is contact-free and requires no changes to the vessel. They are therefore widely used, particularly in difficult processes. Problems can occur however, when weld or material inspections are performed at the plant site. During these inspections very strong radioactive sources are employed, sometimes 10,000 times stronger than the source of the measuring system. This additional radiation field leads to a strong rise in count rate at the detector and a seemingly dropping fill level. As a result, considerable problems in the process can occur - in the worst case, vessel overflow with severe consequences for plant and personnel safety. Up to now, detectors were often covered with heavy and expensive lead shieldings. during weld inspections Weld tests were strongly regulated and the production was often stopped or severly hampered. ...

BERTHOLD Technologies: Radiometric level measurements are particularly reliable and have a characteristically high availability. The technique permits non-contact level measurement and is therefore used especially for difficult measuring tasks. Hitherto, however, the applicability of radiometric measurements was always compromised whenever testing of materials or welds was being performed on site. A newly developed technology now permits the influence of interference radiation on measurement to be drastically reduced. The very high activity of the radiation sources used for weld testing gene rate such strong radiation fields that even radiometric measurements perform ed at distances of up to 1000 m can go haywire. A new technology has been developed to prevent this from happening. An LB440-RID radiometric level measurement system incorporating this new technology was subjected to extensive field testing by BASF radiometry specialists at Ludwigshafen in collaboration with Berthold Technologies in order to establish its applicability in practice. ...

4B introduces a new and improved Rotary Level Indicator. The ATEX approved RotoSafe incorporates two detection circuits. One circuit indicates when material has impeded the paddle, and the other circuit provides indication when the paddle stops turning, therefore making it a failsafe solution for high level or plug condition monitoring in bins, silos elevators or conveyors. Bonus features include user adjustable sensitivity, LED indication and a corrosion resistant housing. Specifications: Supply: 120/240 VAC /24 VDC - Approvals: CE approved for Europe. ATEX versions available - Class 2 Division 1 groups e, f, g for US & Canada - Protection: IP65 – NEMA 4 - Enclosure: Flame-retardant glass fiber reinforced nylon - Output: Changeover Relay Contacts - Weight: 2.25 lb. ...